Ford 2004 Expedition Owner's Manual page 122

Driver Controls
Compass zone adjustment
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn ignition to the ON position.
3. Start the engine.
4. Locate the reset button on the
compass sensor mounted on the
base of mirror.
5. Press and hold for six seconds
and release. You will see that ZONE
appears in the instrument cluster
display.
6. Press and release the button until the desired zone number appears.
Note: The range of zone values are from 01 to 15 and "wraps" back to
01.
7. When you get to the desired ZONE number, hold the button down to
"lock in" the new value.
The cluster display will return to the "normal" mode when the button
has not been pressed for 6 seconds.
Compass calibration adjustment
Perform this adjustment in an open area free from steel structures and
high voltage lines. For optimum calibration, turn off all electrical
accessories (heater/air conditioning, wipers, etc.) and make sure all
vehicle doors are shut.
1. Start the vehicle.
2. Locate the reset button on the
compass sensor mounted on the
base of mirror.
3. To enter the compass calibration
mode, press and hold the button for
greater than eight seconds. The display will then show CAL in the
display window.
122
2004 Expedition (exd)
Owners Guide (post-2002-fmt)
USA English (fus)
3 2 1
4
5
6 7 8 9 1011
15
14
13
12