Cisco 6901 Administration Manual page 85

Chapter 6 Monitoring the Cisco Unified IP Phone Remotely
Table 6-2 Network Configuration Area Items (continued)
Item
CallManager 1–5
DHCP Enabled
DHCP Address Released
Alternate TFTP
Automatic Port
Synchronization
(Cisco Unified IP Phone
6911 only)
SW Port Remote
Configuration
PC Port Remote
Configuration
(Cisco Unified IP Phone
6911 only)
SW Port Setup
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24582-01
Description
Host names or IP addresses, in prioritized order, of the Cisco Unified Communications
Manager servers with which the phone can register. An item can also show the IP address of
an SRST router that is capable of providing limited Cisco Unified Communications Manager
functionality, if such a router is available.
For an available server, an item shows the Cisco Unified Communications Manager server IP
address and one of the following states:
• Active—Cisco Unified Communications Manager server from which the phone is
currently receiving call processing services.
• Standby—Cisco Unified Communications Manager server to which the phone switches
if the current server becomes unavailable.
Blank—No current connection to this Cisco Unified Communications Manager server.
•
An item may also include the Survivable Remote Site Telephony (SRST) designation, which
identifies an SRST router capable of providing Cisco Unified Communications Manager
functionality with a limited feature set. This router assumes control of call processing if all
other Cisco Unified Communications Manager servers become unreachable. The SRST
Cisco Unified Communications Manager always appears last in the list of servers, even if it
is active. You configure the SRST router address in the Device Pool section in
Cisco Unified Communications Manager Configuration window.
Indicates whether the phone uses DHCP.
Indicates the setting of the DHCP Address Released option on the phone's Network
Configuration menu.
Indicates whether the phone uses an alternative TFTP server.
Indicates if the automatic port synchronization is enabled or disabled. When automatic port
synchronization is enabled, it is recommended that both ports be configured for autonegotiate.
If one port is enabled for autonegotiate and the other is at a fixed speed, the phone
synchronizes to the fixed port speed.
Indicates if the software port configuration of the speed and duplex mode for the SW port is
enabled or disabled.
Indicates if the remote port configuration of the speed and duplex mode for the PC port is
enabled or disabled.
Speed and duplex of the switch port, where:
A—Auto Negotiate
•
10H—10-BaseT/half duplex
•
10F—10-BaseT/full duplex
•
100H—100-BaseT/half duplex
•
• 100F—100-BaseT/full duplex
• No Link—No connection to the switch port
Network Setup
6-5