Lighting Instructions - Napoleon BIP 500 Instructions Manual

Lighting Instructions

WARNING!
Open lid
WARNING!
Ensure all burner controls are in the off position. Slowly turn on the gas
supply valve.
Main Burner
Lighting
1. Open grill lid
2. Push and turn any main burner knob
slowly to the high position. If the pilot
lights, continue to push down on the
control knob until the burner lights and
then release.
3. If the pilot does not ignite, then
immediately turn the control knob back
to the 'off position and repeat step 2
several times.
4. If the pilot and burner will not ignite
within 5 seconds, turn the control knob
to the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.
5. If lighting the unit with a match, clip
the match into the supplied lighting
rod. Hold the lit match down through
the grill and sear plate while turning the
corresponding burner valve to high.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners are turned
off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
Do not use rear burner while operating main burner.
Left Left Centre
Right Centre
Burner Burner
Rear Burner Lighting
(if equipped)
1. Open grill lid
2. Remove warming rack.
3. Turn rear burner control to high
position.
4. Press and hold
igniter button until burner lights, or
light by match.
5. If ignition is not immediate, turn
burner control off. Wait 5 minutes.
Repeat.
Right
Burner Burner
Off Position
Side Burner Lighting
(optional)
1. Open burner cover.
2. Turn side burner control to high
position.
3. Press and hold
igniter button until burner lights, or
light by match.
4. If ignition is not
immediate, turn burner control off.
Wait 5 minutes. Repeat.
www.napoleongrills.com
7