Setting Up The Hardware; Preparing For Desk Use; Preparing For Wall Mounting - HP Slate 21 Pro All-in-One User Manual

2

Setting up the hardware

You can install the all-in-one on a desktop or mount it to a mounting fixture such as a wall mount or
swing arm. Be sure to place the all-in-one in a convenient, well-ventilated location. Connect the
cables after you have installed the all-in-one to a mounting fixture.
To set up the all-in-one, ensure that the power is turned off to the all-in-one and all attached
accessories, and then follow the instructions below for your configuration.

Preparing for desk use

To assemble the all-in-one for desktop use:
1. Set the all-in-one face down on a table or desk covered by a clean, dry cloth.
2. Pull the stand outward.
3. Lift the all-in-one to an upright position and place on a flat, stable surface.

Preparing for wall mounting

NOTE: This all-in-one is intended to be supported by UL or CSA Listed wall mount bracket.
To attach the all-in-one to a mounting fixture:
1. Set the all-in-one face down on a flat, soft, protected table or desk surface.
Preparing for desk use 5