Battery Installation - Kenwood DNX6960 Instruction Manual

,;ij~1~~if'·~.j;i~; ,
. ~i;t'~7ote Con~r
, : . :,.N.,>'!
~;;,£4~i~;1!~' ,.~p;~
~11;'1'<i
~,'
For DNX69601 DNX6460BT :This unit can be operated using the Remote Controller (RC-DV331) supplied
with this unit.
For DDX6046BT :This unit can be operated using the Remote Controller (RC-DV340) supplied with this unit.
For DNX61601 DNX6020EXI DNX51601 DDX6161 DDX516 :
Optional Remote Controller KNA-RCDV331 I KNA-RCDV340 is designed for controlling this unit.
Refer to the instruction manual that comes with the remote controller.
~CAUTION
Put the Remote Controller in a place where it will not
move during braking or other operations, A dangerous
situation could result, if the Remote Controller falls down
and gets wedged under the pedals while driving,
Do not leave the battery near fire or under direct sunlight
A fire, explosion or excessive heat generation may result
Do not recharge, short, break up or heat the battery or
place it in an open fire, Such actions may cause the battery
to leak fluid, If spilled fluid comes in contact with your eyes
or on clothing, immediately rinse with water and consult a
physician,
Place the battery out of reach of children, In the unlikely
event that a child swallows the battery, immediately
consult a physician,
Danger of explosion if battery
IS
incorrectly replaced,
Replace only with the same or equivalent type,
DDX SERIES DDX616/DDX6046BT/DDX516
Battery installation
Use two "AAA"/"R03"-size batteries.
Insert the batteries with the + and - poles aligned
properly, following the illustration inside the case.
~
~
• If the Remote Controller operates only over shorter
distances or does not operate at all, it is possible that
the batteries are depleted, In such instances, replace the
both batteries with new ones,
English 83