Finding The Amount Of Time A Signal Takes From The Device To The Gateway And Back; Determining The Device Link Quality; Checking The Device Link Status - AMX NetLinx ZigBee Compatible Gateway and Repeater NXR-ZGW/-ZRP Operation/Reference Manual

NXR-ZGW Browser-based Configuration Manager Pages

Finding the amount of time a signal takes from the device to the gateway and back

1. In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select
Connections under the section Pan.
2. The "Latency" column lists the amount of time the current signal takes to go from the device to the
gateway and back again.

Determining the device link quality

1. In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select
Connections under the section Pan.
2. The link quality is located in the table under the "LQI" column. The status of the channel is as
follows: green is good all the way to red, not recommended.

Checking the device link status

1. In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select
Connections under the section Pan.
2. The status of the device is located in the table under the "Status" column.
22
NXR-ZGW/-ZRP