Connections; Finding A Device's Eui Address; Finding The Device's Description; Determining The Device Type - AMX NetLinx ZigBee Compatible Gateway and Repeater NXR-ZGW/-ZRP Operation/Reference Manual

Connections

All devices connected to the NXR-ZGW is displayed on this page.
FIG. 11 Connections Page
Each device provides the following:
Connections Page
No.
EUI-64
Description
Type
Latency
LQI
Status

Finding a device's EUI address

1. In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select
Connections under the section Pan.
2. The EUI address is located in the Connections table under "EUI-64". Click on the EUI address to
open the PAN Device Details page for this device. (See FIG. 12)

Finding the device's description

1. In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select
Connections under the section Pan.
2. The device's description is located in the table under "Description".

Determining the device type

1. In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select
Connections under the section Pan.
2. The device type is located in the table under "Type".
NXR-ZGW/-ZRP
The Netlinx ID number.
The 64 bit ZigBee EUI address of the device.
The device's description, supplied by the device.
The specific type of device being accessed.
A measure of the amount of time (in milliseconds) for a message round-trip from the device to
the gateway and back.
LQ is the link quality of the RF path between the PAN coordinator and the device. Quality
levels are:
• not recommended
• edge
• marginal
• good
The current status of the device: either "Active" or "Asleep".
NXR-ZGW Browser-based Configuration Manager Pages
21