Mounting Bracket Kit; Attaching The Mounting Brackets To The Chassis - HP 3600 v2 Series Installation Manual

Mounting bracket kit

Figure 17 Mounting bracket kit

Attaching the mounting brackets to the chassis

The 3600 v2 switch provides one front mounting position and one rear mounting position. You can install
the mounting brackets as needed.
Wear an ESD-preventive wrist strap, and make sure that the wrist strap makes good skin contact
1.
and is well grounded.
Align one mounting bracket with the screw holes in the front-mounting position
2.
rear-mounting position
Use M4 screws (supplied with the switch) to fix the mounting bracket to the switch chassis.
3.
Repeat the proceeding steps to attach the other mounting bracket to the chassis.
4.
Figure 18 1U mounting bracket front mounting position
Figure 19 1U mounting bracket rear mounting position
(Figure 19)..
12
(Figure 18) or the