Grounding The Switch By Using The Ac Power Cord - HP 3600 v2 Series Installation Manual

If you have an OT terminal, follow callout A in
•
in) of insulation sheath by using a wire stripper, and then insert the naked metal part through the
insulation covering into the end of the OT terminal. Secure the metal part of the cable to the OT
terminal with a crimper, and then cover it with the insulation covering. Then heat the insulation
covering with a blower to make it completely cover the metal part.
If you do not have an OT terminal, follow callout B in
•
insulation sheath by an appropriate length by using a wire stripper, and then bend the naked metal
part.
Connect the made connector to the grounding post of the grounding strip, and then fasten it with
4.
a hex nut, as shown in
Figure 23 Make the grounding cable connector
Figure 24 Connect the grounding cable to a grounding strip
(1) Grounding post
(3) Grounding cable

Grounding the switch by using the AC power cord

If the installation site has no grounding strips, you can ground an AC-powered switch through the
protective earth (PE) wire of the power cord, but must make sure:
The power cord has a PE terminal.
•
Figure 24.
(2) Grounding strip
(4) Hex nut
16
Figure 23 to make the connector: Peel 5 mm (0.20
Figure 23 to make the connector: Peel the