10/100Base-Tx Ethernet Port Led - HP 3600 v2 Series Installation Manual

Table 18 Seven-segment LED description (II)
LED
Unit

10/100Base-TX Ethernet port LED

Each 10/100Base-TX auto-sensing Ethernet port has a status LED to show port operating status and
activities. The port mode LED shows the type of port status information (for example, port rate or duplex
mode) that the port status LEDs are showing. You can use the port status LED mode switching button to
change the type of displayed port information.
Table 19 10/100Base-TX auto-sensing Ethernet port LED description
Status
Port mode LED
Steady green (rate
mode)
Flashing green (1 Hz)
(PoE mode, available
only for PoE switches)
Steady yellow (duplex
mode)
Status
System status
Port mode LED
LED
Flashing green
(1 Hz) (PoE Steady green
mode)
Port status LED
Steady green
Steady yellow
Flashing yellow (3
Hz)
Off
Steady green
Flashing green (1 Hz)
Steady yellow
Flashing yellow (3
Hz)
Off
Steady green
Steady yellow
Flashing yellow (3
Hz)
Off
Seven-segment (Unit)
LED
The LED displays
different signs.
Description
The port is operating at 100 Mbps. The port status LED fast
flashes when the port is sending or receiving data.
The port is operating at 10 Mbps. The port status LED fast
flashes when the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
PoE power supply is normal.
The device attached to the port requires power higher than
the maximum or currently available PoE output power on
the port.
The port is not outputting power because it is connected to
a non-PD device.
The port is experiencing a PoE failure.
POST has failed on the port.
The port is not supplying PoE power.
The port is operating in full duplex mode. The port status
LED fast flashes when the port is sending or receiving data.
The port is operating in half duplex mode. The port status
LED fast flashes when the port is sending or receiving data.
POST has failed on the port.
No link is present on the port.
51
Description
For example, the
indicates that the switch is
outputting 0 to 20% of the
81 - 100%
61 - 80%
41 - 60% maximum PoE output
21 - 40%
0 - 20%
power.
sign