Connecting The Power Cord - Pioneer AVH-P6300BT Owner's Manual

Section
14 Installation

Connecting the power cord

Microphone (supplied)
Note:
Depending on the kind of vehicle, the
function of 2* and 4* may be different.
In this case, be sure to connect 1* to 4*
and 3* to 2*.
ISO connector
Note:
In some vehicles, the ISO connector may be divided into two. In
this case, be sure to connect to both connectors.
When you connect the separately sold multi-channel
processor (DEQ-P6600) to this unit, do not connect
anything to the speaker leads and system remote
control (blue/white).
74
En
Wired remote input (WIRED REMOTE INPUT)
Hard-wired remote control adapter can be connected (sold separately).
Microphone input Jack (MIC)
4 m
2* 1*
4* 3*
Yellow (2*) Yellow (1*)
Back-up Connect to the constant 12 V
(or accessory) supply terminal.
Red (4*) Red (3*)
Accessory Connect to terminal controlled by
(or back-up) ignition switch (12 V DC).
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
17 cm
17 cm
This product
Connect leads of the same
color to each other.
Fuse resistor
Fuse resistor
Speaker leads
White:
White/black:
Gray:
Gray/black:
Green:
Green/black:
Violet:
Violet/black:
RGB input
Front left 
Front left 
Front right 
Front right 
Rear left  or subwoofer 
Rear left  or subwoofer 
Rear right  or subwoofer 
Rear right  or subwoofer 