Table of Contents
Advertisement
Section
12
Menu operations
System settings
Switching the auxiliary setting
Activate this setting when using an auxiliary
device connected to this unit.
1
Display the system menu.
Refer to Introduction of menu operations on
page 40.
2
Touch AUX Input on the system menu
to turn AUX Input on or off.
Setting AV input
Activate this setting when using an external
video component connected to this unit.
1
Display the system menu.
Refer to Introduction of menu operations on
page 40.
2
Touch AV Input on the system menu to
turn AV Input on or off.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Full) or subwoofer
(Subwoofer) connection. If you switch the
rear output setting to Subwoofer, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for a rear full-range
speaker connection (Full).
! When the DEQ-P6600 multi-channel pro-
cessor is connected to this unit, you cannot
operate this function.
1
Turn the unit off.
Refer to Basic operations of this unit on page
10.
2
Display the system menu.
Refer to Introduction of menu operations on
page 40.
58
En
3
Touch Rear Speaker on the system
menu to switch the subwoofer output or
full-range speaker.
# When no subwoofer is connected to the rear
output, select Full (full-range speaker).
# When a subwoofer is connected to the rear
output, select Subwoofer (subwoofer).
Notes
! Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to Using subwoofer output on
page 42).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Setting the FM tuning step
Normally, the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to
100 kHz. It may be preferable to set the tuning
step to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during
manual tuning.
1
Turn the unit off.
Refer to Basic operations of this unit on page
10.
2
Display the system menu.
Refer to Introduction of menu operations on
page 40.
3
Touch FM Step on the system menu to
select the FM tuning step.
Touching FM Step will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear.
Advertisement
Table of Contents
