System Settings - Pioneer DEH-09BT Owner's Manual

Menu Item
LOUDNESS
[OFF], [LOW], [MID], [HI]
SUB.W*2
[NOR], [REV], [OFF]
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*3 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
LANGUAGE
[ENG](English), [РУС](Russian),
[TUR](Turkish)
12
En
Description
Compensate for clear sound at low volume.
Select the subwoofer phase.
Only frequencies lower than those in the
selected range are output from the subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
Adjust the volume level for each source except
FM.
Each of the below combinations are set to the
same setting automatically.
• USB, iPod, and APP (iPhone)
• BT AUDIO, and APP (Android)
Description
Select the language to display the text
information from a compressed audio file.
Menu Item
CLOCK SET
12H/24H
[12H], [24H]
AUTO PI
[ON], [OFF]
AUX
[ON], [OFF]
BT AUDIO
[ON], [OFF]
PW SAVE*1
[ON], [OFF]
BT MEM CLEAR
[YES], [CANCEL]
BT VERSION
APP CONN.SET*2
[WIRED], [BLUETOOTH]
*1 [PW SAVE] is canceled if the vehicle battery is disconnected and will need to be turned back on once
the battery is reconnected. When [PW SAVE] is off, depending on connection methods, the unit may
continue to draw power from the battery if your vehicle's ignition does not have an ACC (accessory)
position.
*2 Not available when [APP] is selected as the source.
Description
Set the clock (page 4).
Select the time notation.
Search for a different station with the same
programming, even if using a preset station.
Set to [ON] when using an auxiliary device
connected to the unit.
Set the Bluetooth signal on/off.
Reduce the battery power consumption.
Turning on the source is the only operation
allowed when this function is on.
Clear the Bluetooth device data (device list, PIN
code, call history, phone book, preset phone
numbers) stored in the unit.
[CLEARED] appears when data is successfully
deleted.
Displays the system version of the unit and the
Bluetooth module.
Select the appropriate connection method
according to your device.