Stop Light Switch - Subaru Impreza 2004 Service Manual

19.Stop Light Switch

A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the stop light switch connector.
3) Loosen nuts, and unscrew stop light switch to re-
move.
(1) Stop light switch
B: INSTALLATION
1) Screw the stop light switch onto a bracket and
secure it temporarily with a nut.
2) Adjust the stop light switch position, and then
tighten the nut.
<Ref. to BR-73, ADJUSTMENT, Stop Light
Switch.>
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.8 ft-lb)
C: INSPECTION
1) If the stop light switch does not operate properly
(or if it does not stop at the specified position), re-
place with a new one.
Stop Light Switch
(1)
BR-00107
T
BR-00108
BR-73
Specified position: L
2 mm (0.079 in)
L
2) Measure the clearance between threaded end of
stop light switch and stopper.
CAUTION:
Be careful not to rotate stop light switch.
Stop light switch clearance: A
0.3 mm (0.012 in)
(1) Stop light switch
(2) Stopper
(3) Brake pedal
3) If it is not within specified value, adjust it by ad-
justing position of stop light switch.
CAUTION:
Be careful not to rotate the stop light switch.
D: ADJUSTMENT
Loosen the lock nut, and adjust the stop light switch
position until the clearance between threaded end
of stop light switch and stopper (A) becomes 0.3
mm (0.012 in). Then, tighten the lock nut.
BRAKE
BR-00109
(1)
A
(2)
(3)
BR-00110