Table of Contents
Advertisement
2. Enabling the special OSD (on-screen display) menu
3. Checking the current settings
26
AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL
a. Press a menu switch and either the left switch or the right switch to select
the (i) (information) menu. On that menu, press the menu switch to enter the
information menu. There, a display showing the refresh rate and the screen
resolution appears, as in this example:
1600 1200
b. Press the left switch three times, and then press the right switch three times.
Page 1 of the special OSD menu appears, as in this example:
-1-
005 034
2
In this display, the firmware version is shown in the following format:
-1-
c
where
aaa:
DDC-CPU
bbb:
OSD-CPU
c:
Reserved
ddd:
USB-CPU
eee:
FPGA-LOGIC
If the special OSD menu does not appear, press the menu switch to exit
from the OSD menu. Then go to step 2a to try again.
a. Press the left or right switch to enter page 2 of the special OSD menu.
b. In about five seconds, the current settings will be displayed, as in this
example:
-2-
020
3.2 5.0
aaa bbb
ddd eee
Advertisement
Table of Contents
