Disconnecting the cable
CAUTION:
Do not use a digital signal cable other than the one shipped with the product.
Using some other cable may damage the monitor or the video graphics card.
The cable (P/N: 07N2227) is available at iiyama Customer Support Line (refer
to page 21).
Note: Before you begin the procedures below, be sure to read the "Danger
To disconnect the digital signal cable, do the following:
1. Power off your monitor, peripheral units (if any), and computer and unplug them
2. Turn the monitor face down (refer to page 4).
3. Remove the stand rear cover and the connector cover (refer to page 4 and 5).
4. Unhook the cables from the cable clamps and cable hook (refer to page 5).
5. Lift up the cables and take out the connector tool from the rear compartment of
6. Disconnect the power adapter cord from the DC-IN connector (refer to page 6).
7. Insert the connector tool into the thumb screw on the digital signal cable
8. Disconnect the digital signal cable A from video connector A 3 .
9. Store the connector tool back into the rear compartment of the monitor.
Statements" on page iii.
from the power outlet.
the monitor (refer to page 5).
Note: Be sure to press the latch on the connector of the power adapter cord
when unplugging it from the DC-IN connector.
connector A 1 and turn it counterclockwise 2 to loosen the screw.
Note: The video connectors A and B on the monitor are Safety Extra Low
Voltage (SELV) circuits.
Video connector
DC-IN connector
3
Chapter 3. Adjusting and maintaining your monitor
2
2
P/N: 07N2227
Connector tool
1
17