Iiyama AQU5611D BK User Manual page 16

Connecting the digital signal cable
1. Make sure that the video graphics card is installed on your computer.
2. Make sure that the power cord is NOT connected to your computer.
3. Open the cover of your computer, if necessary.
4. Connect the connector end marked "1 PRIMARY" to the DVI port marked "1",
5. If you have opened the cover of your computer, close it.
8
AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL
and the connector end marked "2 SECONDARY" to the DVI port marked "2" of
the video graphics card.
Notes:
a. If you want to use the extended function, then install the program to your
computer now if you have not installed it yet. Then connect the USB
connector to the USB port. If you don't have this program, you can
download it from the following Web site: http://www.iiyama.co.jp
b. Do not connect the USB connector to the USB port if you don't have the
extended function program installed on your computer. Connecting this
connector may damage your monitor, computer, or other attached USB
devices.
c. If your video graphics card has only one DVI port, then connect the
connector of the digital signal cable marked "1 PRIMARY" to the DVI port on
the video graphics card of your computer.
®
d. With the ATI FireGL
2078 (or higher) for the best performance of the monitor. The device driver
is available at the following Web site: http://support.ati.com
™
4 video graphics card, use ATI device driver version