Table of Contents
Advertisement
Updating the settings for your monitor
Unless you change the video graphics card that drives your monitor, there is usually
no need to change the settings. In case the need does arise, a procedure for
changing them is given in this appendix.
This operation must be done carefully. If incorrect parameters are specified, nothing
will be displayed.
Applicable models
The procedure given in this document applies to monitors with firmware at the
following levels:
DDC CPU
OSD CPU
USB CPU
FPGA LOGIC
Procedure
1. Setting
Version 3.2 or higher
Version 5.0 or higher
Version 4.0 or higher
Version 34 or higher
a. Connect the monitor to the personal computer that is to be used as a video
source.
b. Turn on the monitor and the PC. Wait until the system boots and a stable
screen image is displayed. Confirm that the power indicator on the monitor
shows green. If it is steady amber, press "Debug switch" with a stick to turn
on the monitor. (See the following figure).
CAUTION:
Do not use conductive material to press this switch. It may damage the
electric circuit inside of the monitor.
In this case, power indicator will show blinking amber, and image from PC
does not appear.
Some color pattern may appear on screen.
Appendix A. Specifications
25
Advertisement
Table of Contents
