Table of Contents
Advertisement
6.4
To mount the camera from ceiling, a metal wall-mount bracket in separate package
will be needed.
The mounting procedure
Step 1
Get the metal bowl and mounting base, put
them together with screws to make them a
sub-assembly for mounting.
Step 2
Hook the sub-assembly and camera with the
safety cable located on the bottom of camera
put the signal cables throughout the sub-assembly
Step 3
Fasten the sub-assembly and camera
together
connectors. Rotate camera all the way
in direction of clockwise. Fix the base
to camera with the supplied screw and
wrench.
step 4
Get the ceiling mount bracket. Put cables into the
tube,
advise: start with the 9-pin alarm I/O; Take the male
Have all connectors come out the tube from cable
outlet near the top of the bracket.
Step 5
Fasten the camera module (sub-assembly) to
Vidia Srl – Via Vasanello 23, 00189 Roma – Tel +39 0630316333 Fax +39 0630350231 www.vidia.it
Ceiling -drop
at
the
joint
of
part off to reduce connector size, to make
cabling through tube easier ).
(left picture on below
(right picture)
D-sub
), then
.
Advertisement
Table of Contents
