Table of Contents
Advertisement
To build correct network for control communication, every speed dome camera in
the network must have an unique ID number, which is set by the bit 1 to 8 of a 8-bit
DIP switch DS2.
Factory default of device ID is 1
Note:
Find 8-bit DIP switch DS2 on the PC board
DS2
Refer to the tables in the next two pages for ID setting
relation between pin assignments of DIP switch and ID numbers 1 to 255)
The highest ID number of this camera is 255.
All the speed domes in a network must have their unique ID. It is highly
recommended to installers, for future maintenance efficiency and users'
convenience, to mark the ID of each camera onto its corresponding location on
the site map, and make out a list of cameras with their ID numbers.
The DS2 pin assignment for ID setup is in binary format.
Vidia Srl – Via Vasanello 23, 00189 Roma – Tel +39 0630316333 Fax +39 0630350231 www.vidia.it
Bit number
remark: D
ash line "---" in table means to
set the bit to "OFF" position
(the tables shows the
Advertisement
Table of Contents
