Table of Contents
Advertisement
00326A SCC-931T(P)-eng
9/25/02 12:30 PM
Preparing Cables
The following cables are required to install and use the SCC-931T(P).
Power Adapter Cable
The power adapter that plugs
into the SCC-931T(P)'s power
input receptacle has the rated
voltage of DC 12V 600mA or
AC 24V 300mA.
14
Page 14
Video Cable
The cable that connects the
video output terminal of the
SCC-931T(P) to the monitor is a
BNC cable.
Installing SCC-931T(P)
For installing directly on a ceiling
1. Choose an installation site that can sufficiently support the weight of the equip-
ments to be installed.
2. Attach the supplied template to the installation site, drill pilot holes (5 mm diam
eter, min. 35 mm depth), and then install and secure the supplied plastic
anchors (HUD 5).
3. Connect the power cord and video cable, and arrange them so that they will not
be damaged or caught when installing the CAMERA.
4. Remove the DOME COVER to install the CAMERA.
1) Use the supplied L WRENCH to unfasten the 4
BOLTS for CASE fixing by turning them counter-
clockwise as shown in the illustration.
2) Disassemble the ASSY-DOME in the direction
shown in the illustration.
5. Install the CAMERA.
Align the CAMERA's installation holes to the
holes where the PLASTIC ANCHORS are
inserted and then fasten the ASSY SCREW-
TAPPINGS (TH M4 X 30) with O RINGS.
(2 spots) (It will not be waterproof without O
RINGS.)
1)
2)
15
Advertisement
Table of Contents
