Preparing The Cables; Connecting The Cables - Samsung SCC-C4201(P) User Manual

Preparing the Cables

To install and use the camera, first prepare the following
cables.
The requirements for the power adapter, which connects to
the camera's POWER IN terminal, are as follows:
SCC-C4201(P), SCC-C4203(P) : DC12V 600mA
SCC-C4301(P), SCC-C4303(P) : AC24V 300mA
Video Cable
Use a BNC cable, such as the one shown below, to connect
the camera's VIDEO OUT to the monitor.
9
DC12V 600mA

Connecting the Cables

1. Connect one end of the BNC cable to the VIDEO OUT.
2. Connect the other end of the BNC cable to the VIDEO IN
of the monitor.
Video terminals on the back
of the monitor
BNC cable
3. Plug in the power adapter. Use a "minus" screwdriver to
connect one part of the power adapter, which consists of
two lines, to the POWER terminal of the camera as follows :
(GND : the cable marked with a white line)
POWER SELECTION
switch underneath the
power adapte
REMOTE RS-485 POWER
POWER SELECTION switch
underneath the power adapte
REMOTE RS-485 POWER
10