Lighting Instructions - Napoleon LD485 Manual

6

Lighting Instructions

WARNING!
WARNING!
2. Push and turn any main burner knob
slowly to the 'hi' position. This action
will ignite the pilot flame which will in
turn light the selected burner. If the pilot
lights, continue to push down on the
control knob until the burner lights and
3. If the pilot does not ignite, then
immediately turn the control knob back
to the 'off position and repeat step 2
4. If the pilot and burner will not ignite
within 5 seconds, turn the control knob to
the 'off' position and wait 5 minutes for
any excess gas to dissipate. Either repeat
steps 2 and 3 or light with a match.
5. If lighting the unit with a match, clip
the match into the supplied lighting
rod. Hold the lit match down through
the grill and sear plate while turning the
corresponding burner valve to high.
WARNING!
off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
www.napoleongrills.com
Lights
Left Rear
Burner Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply valve.
Main Tube Burner
Lighting
1. Open grill lid.
then release.
several times.
The propane cylinder is equipped with an excess flow device. Unless all burners are turned
Do not use the rear burner (rotisserie burner) with the main burners operating.
Right Centre
Left Centre
Right
Burner
Burner
Burner
Rear Burner Lighting
(Rotisserie Burner)
(if equipped)
1. Open grill lid.
2. Remove the warming rack.
3. Push and turn the rotisserie burner
control knob slowly to the 'hi' position.
This action will ignite the pilot flame
which will in turn light the burner. If the
pilot lights, continue to push down on
the burner control knob until the burner
lights then release.
4. If the burner does not ignite, then
immediately turn the control knob back
to the 'off' position and repeat step 3
several times.
5. If the burner will not ignite within 5
seconds, turn the control knob to the
'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat
steps 3 and 4 or light with a match.
Side Burner
Side Burner Igniter
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn side burner control to
high position.
3. Press and hold igniter button until
burner lights, or light by match.
4. If the burner will not ignite within 5
seconds, turn the control knob to the
'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat
steps 2 and 3 or light with a match.