Table of Contents
Advertisement
Available languages
Available languages
10
Maintenance / Cleaning Instructions
We recommend this gas grill be thoroughly inspected and serviced annually by a qualified service person.
At all times keep the gas grill area free from combustible materials, gasoline and other flammable vapors and
liquids. Do not obstruct the flow of ventilation and combustion air. Keep the cylinder enclosure ventilation
openings (located on the cart sides and at the front and back of the bottom shelf) free and clear from debris.
WARNING!
WARNING!
Avoid unprotected contact with hot surfaces. Ensure all burners are turned off. Clean grill in an area where
cleaning solutions will not harm decks, lawns, or patios. Do not use oven cleaner to clean any part of this
gas grill. Do not use a self-cleaning oven to clean cooking grids or any other parts of the gas grill. Barbecue
sauce and salt can be corrosive and will cause rapid deterioration of the gas grill components unless
cleaned regularly.
Note: Stainless steel tends to oxidize or stain in the presence of chlorides and sulfides, particularly in coastal
areas and other harsh environments, such as the warm, highly humid atmosphere around pools and hot tubs.
These stains could be perceived as rust, but can be easily removed or prevented. To provide stain prevention
and removal, wash all stainless steel surfaces every 3-4 weeks or as often as required with fresh water and/or
stainless steel cleaner.
WARNING!
possibility of burns, maintenance should be done only when the grill is cool. A leak test must be performed
annually and whenever any component of the gas train is replaced or gas smell is present.
Combustion Air Adjustment: (This must be done by a qualified gas installer.) The air shutter is factory set and
should not need adjusting under normal conditions. Under extreme field conditions, adjustments might be
required. When the air shutter is adjusted correctly the flames will be dark blue, tipped with light blue and
occasionally yellow.
•
With too little air flow to the burner, the flames are lazy yellow and can produce soot.
•
With too much air flow, the flames lift erratically and can cause difficulties when lighting.
Adjusting the air shutter:
1. Remove cooking grids and sear plates and leave lid open.
2. Loosen air-shutter lock screw located at the mouth of the burner and open or close air shutter as required.
The normal opening settings are:
Main Tube Burner
*Infra-Red burners have no air adjustment.
3. Light the burners and set to high. Visually inspect burner flames. When the shutters are set correctly, turn
burners off, tighten locking screws, and replace removed parts. Ensure that the insect screens are installed.
Yellow Tipping
www.napoleongrills.com
Always wear protective gloves and safety glasses when servicing your grill.
To avoid the possibility of burns, maintenance should be done only when the grill is cool.
Turn off the gas at the source and disconnect the unit before servicing. To avoid the
Propane 5/32" (4mm)
Natural 5/32" (4mm)
Light Blue
Dark Blue
Burner
Burner Port
Approximately
1/2" (13mm)
Advertisement
Table of Contents
