Engine Operation; Before Starting; Starting - TOHATSU MFS 6A3Z 8A3 9.8A3 Owner's Manual

28 ENGINE OPERATION

ENGINE OPERATION

Before starting

Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock
and pull the starter handle completely
out approximately 10 times in order to
prime the oil pump.

1. Starting

WARNING
!
5
In case engine starts in gear, do not
start cruising. Stop engine immediately
and consult an authorized dealer.
Note
The engine will not start unless the
switch lock has been properly connected
into the emergency stop switch.
WARNING
!
Do not operate the engine with gear
case out of water.
Severe personal injury, or engine dam-
age will result.
Except for USA and Canada model
(regular tank)
① Full open the air vent screw on the
tank cap.
Air vent Screw
For USA and Canada model
(EPA approved tank)
① Full open the air vent screw on the
tank cap and turn the tank cap
until it contacts the tab lock. Close
the tank cap after completely re-
leasing pressure.
Air vent Screw
② Attach the fuel connector to the en-
gine connector.
The arrow mark on the primer bulb
should be facing the engine.
③ Feed fuel to the carburetor by
squeezing the primer bulb until it
is firm.
Engine side
④ Be sure to install the stop switch
lock to the stop switch.
Tab lock
Fuel
Connector
Engine side
Fuel tank side