Scott A2 User Manual page 6

6. Mount the sleeve by inserting the sleeve into the opening of the dashboard and bend out the tabs located around the sleeve with
a screwdriver. Not all tabs will be able to make contact, so examine which ones will be most effective. To secure the sleeve in place,
bend out the appropriate tabs so that they make contact with the dashboard.
7. Reconnect the wire harness and the antenna and be careful not to pinch any wires or cables.
8. If necessary, use the supplied metal strap to secure the back of the unit in place. Use the supplied hardware (Hex Nut (M5mm)
and Spring Washer) to attach one end of the strap to the mounting bolt on the back of the unit. If necessary, bend the metal strap to
fit your vehicle's mounting area. Then use the supplied hardware (Tapping Screw (M5x25mm) and Plain Washer) to attach the other
end of metal strap to a solid metal part of the vehicle under the dashboard.
This metal strap also helps ensure proper electrical grounding of the unit.
9. Slide the unit into the sleeve until it locks into place.
If necessary, fasten the end of the mounting bolt with the short thread to the back of the unit and the end with the long thread to the
dashboard.
GB-5