Notes On Handling - Fujitsu FPC-M80000 User Manual

Notes on handling

When installing a peripheral device, note the following.
Whenever possible, use peripheral devices supplied by Fujitsu.
Malfunction or damage caused by the use of a third-party product instead of the Fujitsu device
shall not be covered by the warranty.
Before using a peripheral device in a category for which Fujitsu does not supply genuine
products, contact the third-party manufacturer to ask whether the device is compatible with
the PC.
Have you finished Windows setup?
Installing a peripheral device on the PC before setup may cause the setup program to fail.
Set up Windows by referring to the Software Guide.
Install one peripheral device at a time.
Installing more than one peripheral devices at a time may cause driver installation to fail.
Turn off the PC and connected devices.
For safety, be sure to unplug the PC and connected devices. Even if the PC is turned off, an
electric current flows in the PC unit.
Do not start work immediately after turning off the power.
Components inside the PC may be still hot. After turning off the power and unplugging the
PC, wait for about 10 minutes before starting work.
Do not disassemble the power supply unit.
The power supply unit is a box-shaped component on the back inside the PC. Since the unit
contains some high-voltage components, do not disassemble it.
Be careful with the cables and components inside.
Do not damage or modify them.
Be careful of static electricity.
PC boards and electronic parts of internal peripheral devices are exposed. They may be
damaged by static electricity generated on your body. Before handling these parts, touch a
large metallic object to discharge static electricity.
Do not touch PC board surface, soldered parts or connectors.
Hold PC boards by the brackets or edges.
Power supply for peripheral devices
Typical peripheral devices should be turned on before turning on the PC, however, some
should be turned on after the PC. See the manual for the peripheral device.
Use ACPI-compatible devices.
Since the PC is controlled as per ACPI (one of the power supply control standards for power
saving), peripheral devices must also conform to the ACPI standard.
The use of a peripheral device not conforming to the ACPI standard may cause malfunction
of the PC or device. Contact the device manufacturer to ask if your device supports ACPI.
Use an appropriate screwdriver.
You must use a Phillips screwdriver to remove slot covers and brackets from the PC.
Use a screwdriver of an appropriate size not to damage screw heads.
29