Table of Contents
Advertisement
8
Connect the power cable.
Connect a free (not used) power cable in the PC unit to the installed internal hard disk.
9
Reinstall the cover.
10 Set the installed hard disks using BIOS Setup.
Set the type of the installed internal hard disk using [Main]-[IDE Drive 1] of BIOS Setup for that
installed first or [IDE Drive 2] for the second (set to [Auto] by default).
After installing hard disks, be sure to check the order to be booted on [Main]-[Boot Options]-
[Boot Sequence] of BIOS Setup.
Point
- For removal, follow the opposite procedure from that for installation.
- After installing the first internal hard disk, use the attached Recovery CD-ROM to configure
sectors and install OS for each sector.
- After installing the second internal hard disk, configure as follows:
• For Windows 98/Me model
After installing a hard disk, use the FDISK command from the MS-DOS prompt to configure
sectors. Then, format the additional hard disk from My Computer.
• For Windows NT model
On Disk Administrator, configure sectors and format the hard disk.
Disk Administrator is activated by clicking the [Start] button, [Program], then [Administration
tools (common)].
• For Windows 2000 model
Select [Control Panel]-[Administration tools]-[Administration of computer]-[Administration of
disk], configure hard disk sectors, and format the disk.
45
Advertisement
Table of Contents
