Install Crisperkeeper™ Produce Preserver - Kenmore 106.5116 Use & Care Manual

Location 2:
Install the other filter in the filter housing assembly, which is
located along an interior side wall of the crisper and/or
convertible drawer.
NOTE: There are two housing assemblies. Use one for one of the
CleanFlow™ Air Filters, and use the other for the
CrisperKeeper™ Produce Preserver pouches. Do not install
Air Filters and Produce Preserver pouches in the same housing
assembly. See "Install CrisperKeeper™ Produce Preserver" for
additional information.
1. Remove the air filter from its packaging.
2. Lift up on the housing in order to remove it from its mounting
tab along the wall.
3. Snap the filter into place on the rear of the housing.
4. Place the housing back on the mounting tab along the wall.
Installing the Filter Status Indicators (on some models)
Each filter comes with a status indicator, which should be
activated and installed at the same time the air filter is installed.
14
Location 1:
1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator,
until the bubble pops to activate the indicator.
3. Lift open the vented air filter door. There are notches behind
the door. Slide the indicator down into the notches, facing
outward.
NOTE: The indicator will not easily slide into the notches if
the rear bubble has not been popped.
4. Close the air filter door, and check that the indicator is
visible through the rectangular hole in the door.
Location 2:
1. Place the indicator face-down on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator,
until the bubble pops to activate the indicator.
3. Slide open the cap on the housing assembly.
4. Place the indicator in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator is visible
through the rectangular hole in the cap.
NOTE: The cap will not easily close if the indicator's rear
bubble has not been popped.
Replacing the Air Filter
The disposable air filter should be replaced every 6 months,
when the status indicator has completely changed from white to
red.
To order a replacement air filter, see "Accessories."
1. Remove the old air filter by squeezing in on the side tabs.
2. Remove the old status indicator.
3. Install the new air filter and status indicator using the
instructions in the previous sections.
Install CrisperKeeper™ Produce Preserver
(on some models)
On some models, your refrigerator's accessory packet includes
a Produce Preserver, which should be installed prior to use. On
some models, the Produce Preserver is already installed at the
factory.
The Produce Preserver absorbs ethylene, allowing the ripening
process of many produce items to slow down. As a result, certain
produce items will stay fresh longer.
Ethylene production and sensitivity varies depending on the type
of fruit or vegetable. To preserve freshness, it is best to separate
produce with sensitivity to ethylene from fruits that produce
moderate to high amounts of ethylene.