Bottle/Can Rack; Refrigerator Shelves; Wine Rack; Deli Drawer - Kenmore 106.5116 Use & Care Manual

Bottle/Can Rack

(on some models)
To Remove and Replace the Bottle/Can Rack:
1. Remove the bottle/can rack by lifting it and pulling it
straight out.
2. Replace the bottle/can rack by sliding it in above the
desired supports and pushing it down until it stops.

Refrigerator Shelves

(number of shelves varies by model)
Store similar foods together and adjust the shelves to fit
different heights. This reduces the time the refrigerator door is
open and saves energy.
To Remove and Replace a Shelf:
1. Pull the shelf forward to the stop. Tilt the front of the shelf up
and lift it slightly as you pull the shelf from the frame.
2. Replace the shelf by guiding it back into the slots on the
frame and pushing the shelf in past the stop.

Wine Rack

(on some models)
The wine rack can be placed on any set of refrigerator shelf
supports, either with (as shown below) or without a shelf on the
same supports.
NOTE: If the wine rack is sharing a set of supports with a shelf,
you must first remove the shelf in order to remove the wine rack.

Deli Drawer

(on some models)
The deli drawer stores raisins, nuts, spreads, and other small
items at normal refrigerator temperatures.
To Remove and Replace the Deli Drawer:
1. Remove the deli drawer by sliding it straight out to the stop.
Lift the front and slide the drawer out the rest of the way.
2. Replace the deli drawer by sliding it back past the stop.
Convertible Vegetable/Meat Drawer,
Crisper and Covers
(on some models)
Crisper and Convertible Vegetable/Meat Drawers
To Remove and Replace Drawers:
1. Slide crisper or meat drawer straight out to the stop. Lift the
front of drawer with one hand while supporting the bottom
of drawer with the other hand and slide the drawer out the
rest of the way.
2. Replace the crisper or meat drawer by sliding it back in fully
past the drawer stop.
Crisper and Convertible Vegetable/Meat Drawer Covers
To Remove and Replace Covers:
1. Remove the crisper and meat drawer. Press up in center of
crisper glass insert until it rises above the plastic frame.
Holding the crisper glass firmly, slowly slide the glass insert
forward to remove. Lift crisper cover frame and remove.
Repeat steps to remove the meat drawer cover.
2. Replace back of meat drawer cover frame into supports or
slides on side walls of the refrigerator and lower or slide the
front of the cover frame into place. Slide rear of glass insert
into cover frame and lower front into place. Repeat steps to
replace the crisper cover.
23