Kenmore 106.5116 Use & Care Manual page 20

5. To dispense water, press a sturdy glass against the dispenser
pad OR place the glass below the dispenser opening and
press either the DISPENSE WATER button or the ACCENT
LIGHT button. Hold the glass close to the water dispenser
spout to ensure that the water dispenses into the glass.
A. Water dispenser spout
NOTE: While dispensing water, the digital display will count
down how much water remains to be dispensed, according
to the volume you selected. The flow of water will
automatically stop once the desired volume has been
dispensed.
6. To stop dispensing before the selected volume has been
dispensed, remove the glass from the dispenser pad OR
press either the DISPENSE WATER button or the ACCENT
LIGHT button a second time.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the digital display will continue to show
how much water remains to be dispensed. The display will
turn off after 1 minute of inactivity.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when
the dispenser pad is pressed. To turn off the ice maker, see "Ice
Maker and Storage Bin."
Your ice maker can produce both crushed and cubed ice. Before
dispensing ice, select which type of ice you prefer by pressing
the WATER/ICE button.
The display screen indicates which type of ice is selected.
CRUSHED
For crushed ice, cubes are crushed before being dispensed. This
may cause a slight delay when dispensing crushed ice. Noise
from the ice crusher is normal, and pieces of ice may vary in
size. When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the first cubes.
20
A
CUBED
To Dispense Ice:
1. Make sure the desired type of ice is selected. To switch
between cubed and crushed, press WATER/ICE.
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser pad. Hold the
glass close to the ice guide to ensure that the ice dispenses
into the glass.
A. Ice guide
IMPORTANT: You do not need to apply a lot of pressure to
the pad in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
NOTE: To dispense both water and ice at the same time,
press the DISPENSE WATER button while using the dispenser
pad to dispense ice.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds
after removing the glass from the pad. The dispenser may
continue to make noise for a few seconds after dispensing.
The Dispenser Light
The dispenser has two separate lights: a white dispenser light
and a blue dispenser pad light.
The white dispenser light automatically turns on when you use
the dispenser, then turns off when dispensing stops.
The blue dispenser pad light can be manually turned on or off.
Press the ACCENT LIGHT button to turn the dispenser
pad light on. The display screen indicates when the light
is on.
A