Draining; Emptying The Drip Tray - Keurig B3000 Use & Care Manual

Draining the B3000 Brewer
If you wish to drain the brewer, the following
steps should be followed:
1. Turn off the Brewer and unplug power cord.
2. Turn the brewer around (shut off water and
disconnect water supply if necessary) so
the back is facing you.
3. Unclip the drain hose(s) from their holders
(see page 6) and lower them. Move the bre-
wer close to the edge of the counter so that
the drain hoses overhang.
4. Place a container under the hoses and
remove the drain plugs.
CAUTION: The water may be very hot!
NOTE: The process to completely drain the
brewer takes about 200 seconds.
5. When the flow of water stops replace both
drain plugs and clip the drain hoses back
into place.
The brewer's internal hot water tank and
aold water tank are now empty.
6. When you power up the brewer again it will
display:
"WAS THE BREWER
DRAINED? YES NO
Answer YES to the question so
that it will start to prime the brew-
er.

Emptying the drip tray

To empty the drip tray grasp the drip tray by
the side as shown and pull it towards you.
Image shows drip
tray removed
Pull here to remove
drip tray
11