Advertisement
MONITOR – Uninterrupted surveillance of alarm sensors
1 MON/NEW ENTRY
2 ON-OFF/VU LOG
Press '1' to MONITOR or ENTER NEW PROGRAM
Press '2' to TURN STATION ON – OFF or VIEW STATION LOG
(Press '1' to begin monitoring process)
•
Screen will then display
1 MONITOR
2 ADD TX/REVIEW
Press '1' to MONITOR (only if STATION(S) 01 – 40 have been previously programmed)
Press '2' to ADD TRANSMITTER or REVIEW STATION'S PROGRAM
(Press '1' to have uninterrupted surveillance of alarm sensors)
•
Screen will then display
MONITORING!
('M' TO CANCEL)
After properly programming the wireless grid of remotely located transmitters, the EM-900 WA is now ready to
perform its duty of monitoring the following conditions:
ALARM caused by tripping a remote sensor connected to its transmitter (only if ENABLED).
•
Tx MISSING when a transmitter stops operating for more than 30 minutes in a row or is completely removed
•
from the area under surveillance (only if ENABLED).
LOW BATTERY of transmitter STATION when voltage drops below 2.5V (only if ENABLED).
•
Any of the following messages may appear during the monitoring phase.
ALARM!
Or
Tx MISSING!
Or
LOW Tx BATTERY!
7
Advertisement
