Advertisement
Press '2' to VIEW STATION LOG
(Press '2' to VIEW DATA LOG information)
•
Then, in sequence you'll see the following messages
MISSING TX LOG:
If there were 3 missed check-in codes in a row the display shows
RESET TO 0?
YES(1) NO(2)
YES if you want the count to be reset to 0, otherwise it will remain in memory.
Changing a transmitter code
If a stored code needs to be changed, follow these steps.
First go to initial setup prompt by scrolling through display or by simply turning power switch off and back on with
adaptor unplug from unit. Identify the memory location of the transmitter code you wish to change.
1 MON/NEW ENTRY
2 ON-OFF/VU LOG
Press '1' to MONITOR or ENTER NEW PROGRAM
Press '2' to TURN STATION ON – OFF or VIEW STATION LOG
(Press '1' to begin programming)
•
Screen will then display
1 MONITOR
2 ADD TX/REVIEW
Press '1' to MONITOR (only if STATION(S) 01 – 40 have been previously programmed)
Press '2' to ADD TRANSMITTER or REVIEW STATION'S PROGRAM
(Press '2' to setup transmitter(s) with assigned code)
•
Screen will then display
1 ADD NEW TX
2 REVIEW STATION
Press '1' to ADD a TRANSMITTER to a particular STATION
Press '2' to REVIEW STATION (01 – 40) PROGRAM
(Press '1' to add a new (or change) transmitter code to selective station)
•
0
3
11
Advertisement
