Advertisement
ENTER STATION #:
THEN (*)
Enter 01 (for station 01)
Go to memory location 01 which should contain code 1234 from previous example.
Enter 01
STATION:01
Shortly thereafter the previously stored code is displayed
1234
ENTER Tx CODE:
THEN (*)
To continue with the setup, refer to the "LOC" setup on the bottom of page 4.
You may now enter the new code, and re-program the designated transmitter.
OR
*
By simply pressing
(star button) you will be asked
WIPE RECORD?
YES(1) NO(2)
If YES, the previously stored record will be wiped and that location is pre-empted for future use.
Finally
DONE?
YES(1) NO(2)
If NO you may continue programming additional transmitters (or changing codes) until memory is full or if YES you
will exit the PROGRAM Tx mode and go to CONFIGURE.
12
Advertisement
