Advertisement
Important: Under normal operating conditions the STATION should remain in its
recharging cradle to keep the battery at full capacity. This will allow portable
operation when needed for up to four hours.
YES to program the transmitter via program cable, resulting in the message
CONNECT Tx CABLE
THEN...
Familiarize yourself with the procedure of connecting the 3-wire program cable (tucked inside the back
compartment of the EM-900 WA) to a transmitter module. See pictures on the last page. First, remove the
transmitter cover and look at the illustrations for the different models that can be used with the EM-900 WA. After
you have correctly attached the cable, momentarily press the reset button shown in the pictures. You should hear
2 short 'beeps' simultaneous with the front light flashing, indicating that programming the transmitter is successful
and complete. The EM-900 WA keeps a profile of all the codes programmed and can therefore determine while in
the MONITORING mode which transmitter is tripped.
CAUTION: If you decide to press the 'M' TO CANCEL option instead of pushing the Tx reset button, even with the
programming cable attached, the new code will not be stored inside the transmitter. Therefore, the EM-900 WA
will not recognize any alarms from that particular transmitter.
PRESS Tx RESET
OR 'M' TO CANCEL
13
Advertisement
