Table of Contents
Advertisement
Battery Installation
NOTE
Do not pull the sled out
any farther than
the battery compartment.
It is very hard to line up
the sled guides if
it comes out to far
End view of tank car
Installing the battery
1. Grab the electronics sled and pull it out. Be careful not to pull too far to avoid removing
the sled from it's guides on the inner walls of the tank cylinder.
If the sled is completely removed, be careful when reinstalling to align the sled
Note!
into the guides along the inner walls of the tank car. If the sled is not in the
guides, it can not be mated to the electrical connector in the rear of the cylinder.
2. Connect a 9V battery and place it in the sled.
3. Gently push the sled back into the cylinder until the sled snaps into the rear connector.
Do not force the sled into the cylinder as the sled should easily snap into the connector if
properly inserted into the guides along the inner walls of the cylinder.
Although the LEGACY RailSounds sound system is powered through the track,
Note!
we recommend that you install a nine-volt alkaline battery in the car to prevent
the sound system from shutting down during track power interruptions (for
example, at a switch or a dirty section of track). Follow these steps and see
above as you install the battery.
72-7410-250 VL Ethanol Tankcar.indd 5
5
Figure 2
4/13/10 8:01 AM
Advertisement
Table of Contents
