Step 5: Installing The Bottom Trim - Thermador C272 Installation Instructions Manual

STEP 5: INSTALLING
THE BOTTOM TRIM
(except CJ301)
Install the bottom vent trim and se-
cure with (2) screws provided, one at
each top end corner of the trim. The
sheet metal bottom of the oven should
be under the trim, except for the
section at the center. To install the
screws, open the door. The holes are
visible at each end below the left and
right hinges. Place and tighten screws.
See Fig. 6 View 'A'.
Thermador reserves the right to change specifications or design without notice. Some models are certified for use in
Canada. Thermador is not responsible for products which are transported from the United States for use in Canada. Check
with your local Canadian distributor or dealer. Thermador, 5551 McFadden Avenue, Huntington Beach, CA 92649.
For the most up to date critical installation dimensions by fax, use your fax handset and call 702/833-3600. Use code #8030.
5551 McFadden Avenue, Huntington Beach, CA 92649 • 800/735-4328
RO 8590 • 16-11-461A • ©2001 BSH Home Appliances Corp. • Litho Date: 8/01
View 'A'
Side
Fig. 6 - Installing
View
Bottom Trim
'A'