2.1 Installing the Printer
In addition to regular horizontal installation, the printer can be hung on a wall using the
optional WH-10 Wall Hanging Bracket Set.
2.1.1 Precautions for Horizontal Installation
❏ Install the printer in a flat, horizontal position.
❏ Avoid locations susceptible to dust and other foreign matter.
❏ Be sure to avoid bumping so that the printer is not exposed to strong impact during
operation.
❏ Avoid placing the printer on top of the power supply or other cables or other objects.
2.1.2 Precautions for Wall Installation
❏ Make the following settings on the printer when you hang it on a wall. For details, refer to
the installation manual provided with the optional WH-10 Wall Hanging Bracket Set.
•
Install the roll paper stopper
•
Adjust of near-end detector
•
Attach the connector cover
•
Install the WH-10 Wall Hanging Bracket Set
❏ For other details, refer to the installation manual provided with the optional WH-10 Wall
Hanging Bracket Set option.
CAUTION:
When hanging the printer on the wall with the hanging bracket set, be sure to attach a
connector cover to the printer.
2.2 Setting the DIP Switches
On this printer, you can make various settings with DIP switches.
Note:
Serial interface communication conditions must be set on serial interface model printers.
2.2.1 DIP Switch Positions and Steps for Changing DIP Switch Settings
Follow the steps below to change the DIP switch settings.
2-2 Setup
Rev. A