BOMBARDIER EVEREST Operator's Manual page 35

Chassis
Clean the vehicle thoroughly, removing
all dirt and grease accumulation.
~
CAUTION: Plastic alloy cornpo-
... nents such as fuel tank, wind-
shield, controls,
etc.,
can be cleaned
using mild detergents or isopropyl al-
cohol. Do not use strong soaps, de-
greasing solvents, abrasive cleaners,
paint thinners, etc.
Inspect the hood and repair any dam-
age. Repair kits are available at your
authorized dealer. Clean the frame. For
the aluminum portion use only
II
Alumi-
num cleaner" and follow instructions
on the container.
Touch up all metal spots where paint
has been scratched off. Spray all bare
metal parts with metal protector. Wax
the hood for better protection.
O
NOTE: Apply wax on glossy fin-
ish of hood only. Protect the ve-
hicle with a cover to prevent dust accu-
mulation during storage.
. . CAUTION: If for some reasonthe
... snowmobile has to be stored out-
side it is necessary to cover it with an
opaque tarpaulin. This caution will pre-
vent the sun rays affecting the plastic
components and the vehicle finish.
Battery
Remove battery from vehicle and clean
outside surface of battery with solution
of baking soda and water. Remove all
deposits from posts then rinse with
clear tap water.
. . CAUTION: Do not allow cleaning
... solution to enter battery interior
since it will destroy the electrolyte.
Check electrolyte level. Refill if neces-
sary with distilled water. Fully charge
battery. (A stored battery should be re-
charged at least every 40 days).
. . . CAUTION: Prior to charging the
... battery, always remove it from
the vehicle to prevent electrolyte spill-
age.
•
WARNING: Gases given off by a
battery being charged are highly
explosive. Always charge in a well ven-
tilated area. Keep battery away from
cigarettes or open flames. Avoid skin
contact with electrolyte.
Coat battery terminals with petroleum
jelly and store unit in a cool, dry place.
General Inspection
Check the electrical wiring and compo-
nents, retighten loose connections.
Check for stripped wires or damaged
insulation.
Thoroughly inspect the vehicle and
tighten loose bolts, nuts and linkage.
O
NOTE: Leave the drive belt off
the pulleys for the entire storage
period.
33