To adjust, remove headlamp chrome
ring, turn upper or lower adjusting
screws to obtain desired beam posi-
tion.
If taillight bulb is burnt, expose the
bulb by removing the red plastic lens.
To remove, unscrew the two (2) Phillips
head screws.
•
WARNING: Always check light
operation after bulb replacement.
General Inspection
Check the electrical wiring and compo-
nents, retighten loose connections.
Check for stripped wires or damaged
insulation. Thoroughly inspect the ve-
hicle and tighten loose bolts, nuts and
linkage. Inspect skis and ski runners for
wear.
Bulb Replacement
If the headlamp bulb is burnt, tilt hood,
unplug the connector from the head-
lamp. Remove the rubber boot and un-
fasten bulb retainer clips. Detach the
bulb and replace.
~
C/
1
0
~
50mm
Intensity zone
of high beam
(projected on
the wall)
, - " " ] r ' 7 "_ _ , "
Headlamp
horizontal
center line
Center line
intensity zone
With the suspension correctly adjust-
ed, the rider seated on the vehicle and
the high beam ON check that the cen-
ter of high intensity zone of high beam
is 50 mm (2") below horizontal line of
headlamp height.
29