Ice-O-Matic ICE0250 Series Service And Installation Manual page 51

ICE Series
Water Splash Curtain
The water splash curtain covers the evaporator to prevent water from splashing into the bin and is
also used to actuate the bin switch. When the bin becomes full of ice, the splash curtain is held
open when the ice drops off of the evaporator. The actuator tab or wire bale on the splash curtain
will release pressure on the bin switch and the machine shuts off. See bin control on page F9.
On single evaporator units, the splash curtain can be opened or removed during the freeze cycle
and the machine will continue to run until the ice drops from the evaporator. On dual evaporator
units, if the curtain is opened or removed during the untimed freeze cycle, or during defrost, the
machine will shut down. If the curtain is opened or removed during the timed freeze cycle, the unit
will continue to operate.
The splash curtain can be removed by swinging the bottom of the curtain away from the
evaporator and lifting the right side of the curtain up and out of the hinge pin slot. To reinstall the
curtain, position the left side pin into the slot first, then insert the right hand side with the actuator
tab of the curtain behind the bin switch.
Note: The ICE0250 and ICE0305 utilize a curtain-retaining clip. The ICE Undercounter Series
ice machines do not utilize a splash curtain.
Proper position of wire bale switch actuator
Water splash curtain actuator tab
positioned behind bin switch
Page D3
Water System