Ice-O-Matic ICE250 through ICE2100 SERIES Installation And Maintenance Manual

Ice-O-Matic ICE250 through ICE2100 SERIES Installation And Maintenance Manual

Ice series cubers

Advertisement

Installation, Start-Up and Maintenance Manual
ICE SERIES CUBERS
ICE0250 through ICE2100 SERIES*
*Includes Undercounter and 22 Inch Series
ICE-O-Matic
11100 East 45th Ave
Denver, Colorado 80239
Part Number 9081264-01
Print Date 3/05

Advertisement

Table of Contents
loading

Summary of Contents for Ice-O-Matic ICE250 through ICE2100 SERIES

  • Page 1 Installation, Start-Up and Maintenance Manual ICE SERIES CUBERS ICE0250 through ICE2100 SERIES* *Includes Undercounter and 22 Inch Series ICE-O-Matic 11100 East 45th Ave Denver, Colorado 80239 Part Number 9081264-01 Print Date 3/05...
  • Page 2 Series (electro-mechanical) cube ice machines. Do not attempt to perform installation, start-up or maintenance unless you have read and fully understand this manual. If at any time you encounter conditions that are not addressed in this manual, call, E-mail or write the ICE-O-Matic Service Department: ICE-O-Matic 11100 E.
  • Page 3: Table Of Contents

    ICE Series Forward Table of Contents Freight Claim Procedure Warranty Model Number and Serial Number Format Installation Guidelines Remote Condenser Guidelines Electrical and Plumbing Requirements How the Machine Works Start-Up Procedure General Maintenance Cleaning Procedure Cabinet Care Winterizing Procedure Maintenance Record Page ii Table of Contents Page i...
  • Page 4: Freight Claim Procedure

    If loss or damage does not appear until merchandise has been unpacked, make a written request for inspection by the carrier within 15 days of the delivery date. Then file a claim on a form from the carrier. File Claim Without Delay Do Not Return Damaged Merchandise to ICE-O-Matic Page iii...
  • Page 5: Warranty

    Domestic & International Warranty Mile High Equipment Company (the “Company”) warrants Ice-O-Matic brand ice machines, ice dispensers, remote condensers, and ice storage bins to the original user customer against defects in material and factory workmanship for a period of thirty-six(36) months on cube ice machines and twenty-four (24) months on flake ice machines, “compressed ice”...
  • Page 6: Model Number And Serial Number Format

    Series: Environmental Cuber (Uses HFC Refrigerant) This format is 14 characters long and begins with a date code followed by the ICE-O-Matic identifier, and then a sequential number. This is an entirely numerical serial number. The serial number will look like the example.
  • Page 7: Installation Guidelines

    Self contained air cooled ice machines must have a minimum of 6 inches (15cm) of clearance at the rear, top, and sides of the ice machine for proper air circulation. Stacking If the ice machines are to be stacked, refer to the instructions in the stacking kit. ICE-O-Matic does not endorse stacking air-cooled ice machines. Dispenser Application A thermostatic bin control kit should be installed if the ICE Series ice machine is placed on a dispenser.
  • Page 8 Attach the ice machine to the bin with the mounting straps provided with the bin or dispenser. If the ice machine is to be mounted on a bin or dispenser other than an ICE-O-Matic, refer to the manufactures instructions for machine mounting.
  • Page 9: Remote Condenser Guidelines

    ICE Series Remote Condenser Installation For proper operation of the ICE-O-Matic ice machine, the following installation guidelines must be followed. Failure to do so may result in loss of production capacity, premature part failure, and may void all warranties. Remote condensers must be installed per local building codes. A two to four inch diameter roof penetration will be needed for refrigerant lines and electrical conduit.
  • Page 10 Master). Only one valve is required per system. Kits are available to modify the ice machine or condenser for compatibility. For more information contact your ICE-O-Matic Distributor. 10 ft. drop x 6.6 + 34 ft horizontal = 100 equivalent feet line run Remote Condenser Guidelines...
  • Page 11: Electrical And Plumbing Requirements

    ICE Series Electrical and Plumbing Requirements: ICEU150, 220, 225 and 226 Note: The ICEU150, 220, 225 and 226 do not have a splash curtain. These models utilize a thermostatic bin control in place of a mechanical bin switch. Electrical and Plumbing Requirements Page 6...
  • Page 12 ICE Series Electrical and Plumbing Requirements: ICEU300 Note: The ICEU300 Series do not have a splash curtain. This models utilize a thermostatic bin control in place of a mechanical bin switch Electrical and Plumbing Requirements Page 7...
  • Page 13 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE0250, ICE0400, ICE0500 ICE0600 Page 8...
  • Page 14 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE0806 and ICE1006 Page 9...
  • Page 15 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: 48 Inch Wide Cubers Page 10...
  • Page 16 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: 22 Inch Wide Cubers Page 11...
  • Page 17 ICE Series Electrical and Plumbing Requirement Electrical and Plumbing Requirements: ICE1606 Remote Page 12...
  • Page 18 ICE Series Electrical and Plumbing Requirements Electrical and Plumbing Requirements: ICE1506 Remote Page 13...
  • Page 19: How The Machine Works

    ICE Series How the ICE Machine Works How the ICE Machine Works A general description of how the ICE Series cubers work is given below. With the ICE/OFF/WASH switch in the ICE position, the compressor, water pump and condenser fan motor (when applicable) will energize starting the freeze cycle.
  • Page 20: Start-Up Procedure

    ICE Series Start-Up Procedure Before starting the machine, make sure the machine is level within 1/8 inch in all directions, the bin or dispenser leg height can be adjusted by rotating the leg foot. Check the water level in the water trough. It should be approximately ½ inch above the top of the water pump impeller housing.
  • Page 21 ICE Series Bin Control Operation The bin control is used to shut the machine off when the bin fills with ice. The bin control must be checked upon installation or initial start-up and when performing maintenance. Adjustments are not covered under warranty. There is one bin switch for each evaporator.
  • Page 22: General Maintenance

    ICE Series Electrical shock and/or injury from moving parts inside this machine can cause serious injury. Disconnect electrical supply to machine prior to performing any adjustments or repairs. Failure to perform the required maintenance at the frequency specified will void warranty coverage in the event of a related failure.
  • Page 23: Cleaning Procedure

    ICE Series Ice Machine Cleaning and Sanitizing Instructions 1. Remove the ice machine front panel. 2. Make sure that all the ice is off of the evaporator. If ice is being made, wait for cycle completion, then turn the machine “OFF” at the ICE/OFF/WASH selector switch. 3.
  • Page 24: Cabinet Care

    ICE Series Cleaning stainless steel Commercial grades of stainless steel are susceptible to rusting if not properly maintained. It is important that you properly care for the stainless steel surfaces of your ice machine and bin to avoid the possibility of rust or corrosion. Use the following recommended guidelines for keeping your stainless steel looking like new: 1.
  • Page 25: Winterizing Procedure

    ICE Series Winterizing Procedures Important! Whenever the ice machine is taken out of operation during the winter months, the procedure below must be performed. Failure to do so may cause serious damage and will void all warranties. 1. Turn off water to machine. 2.
  • Page 26 ICE Series Service History Service History Model Number__________________Serial Number__________________Date Installed__________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________...

This manual is also suitable for:

Ice0250Ice2100

Table of Contents