Operational Summary; Rudder Eyepiece Cup; Diopter Adjustment; Measuring - Nikon Callaway XHOT Instruction Manual

Operational Summary
Caution-use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure
1. Install a battery in the battery chamber. (See "Changing Batteries")
2. Rubber eyepiece cup
Eyeglass wearer: Collapse the eyepiece cups.
Non-eyeglass wearers: Do not collapse the eyepiece cups.
3. Diopter adjustment
Adjust diopter to obtain a clear image in the LCD.
First, rotate the diopter adjustment ring counterclockwise until it comes to a complete stop. Next, turn on the power to activate the
LCD when you look through the Laser Rangefinder. Rotate the diopter adjustment ring clockwise until the display comes into focus.
If the diopter is not adjusted to correspond to your eyesight, you may not be able to clearly focus your subject.
4. Measuring
Note: Depressing and holding down the POWER button causes all symbols to be displayed in the LCD panel. After you remove your finger
from the POWER button, the last-used setting is displayed. (If you briefly press the POWER button then remove your finger, the LCD panel
may display the last-used setting without displaying all of the symbols. This is not a malfunction or other problem.)
Before measuring, be sure to confirm unit setting.
8 seconds pass without
operation
*
Power off: LCD indications disappear.
I
J
*
Power turns off B seconds after the last operation.
1:.r
[Continuous measurement mode)
For continuous
measurement mode
(for 8 seconds)
IPOWEAI Depressing the POWER button allows you to perform continuous measurement for 8
seconds. The Laser Rangefinder doesn't have a single measurement function .
Blinks while performing measurements.
When measuring a pin at a golf course, for example, use the continuous measurement mode for
easy measurement. With no objects between you and the pin, the Laser Rangefinder measures
the distance to your targeted pin.
5. Selecting display unit (default setting is yards.)
r
Meter[ml
~
Yard[YDI
~
1. Confirm the internal LCD panel is on.
2. Press and hold the MODE button (more than two seconds.)
3. When display unit has switched, release the MODE button.
4. Repeat steps 2 and 3 until your desired mode is displayed.
5. When you have completed setting, results will be converted and displayed in the your selected measurement unit.
6. Distance display
The Laser Rangefinder has a First Target Priority System. When measuring overlapping subjects, this equipment displays the distance
to the closest subject.
7. Low battery indication
Flashing
~
indicates that the battery charge is low and battery should be replaced. (See "Changing Battery")