GigE Vision Host Control Category
The GigE Vision Host controls, as shown by CamExpert, groups parameters used to configure the host computer system
GigE Vision features used for Genie TS networking management. None of these parameters are stored in any Genie TS
camera.
These features allow optimizing the network configuration for maximum Genie bandwidth. Settings for these parameters are
highly dependent on the number of cameras connected to a NIC, the data rate of each camera and the trigger modes used.
Information on these features is found in the Teledyne DALSA Network Imaging Module User manual.
File Access Control Category
The File Access control in CamExpert allows the user to quickly upload various data files to the connected Genie TS. The
supported data files are for Genie TS firmware updates, Flat Field coefficients. LUT data tables, and a custom image for use
as an internal test pattern. Note that a Genie TS Framework installation includes a
camera firmware file
corresponding to the
framework.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or third party software
usage—not typically needed by end user applications.
Operational Reference 83
Genie_TS_Series GigE Vision Camera