EXPORTING DATA TO A FLASH DRIVE
Data can be copied from the control board memory to
a flash drive and used to transfer setup and/or cycle
data to a replacement control board or to transfer
setup information to multiple ice machines. Data may
also be requested by service department personnel for
analysis or as an aid to troubleshooting. The data files
are small and can be attached to an email.
The flash drive must be formatted before using,
Refer to page 71 USB Flash Drive Specifications
and Formatting.
1. Ensure that the ice machine's power is on.
2. Press the Menu button.
3. Press the Down arrow until Service is highlighted.
4. Press the Checkmark. The Service menu will be
displayed.
USB Setup
5. Press the Down arrow until USB Setup is
highlighted.
6. Press the Checkmark. USB Stick will appear
highlighted.
7. Press the Checkmark again. A submenu with
Export ALL and Export Setup appears.
NOTE:
There are four files stored in ice machine memory:
•
Asset Data - ASDATAoo.CSV
•
Operating Data - OPDATAoo.CSV
•
Real Time Data - RTDATAoo.CSV
•
Ice Machine Settings - Settinoo.CSV
Part Number STH038 5/12
Important
USB Stick
Export All
75