Basic Specifications; Unpacking; Set Up Instructions - Chicago Electric 97906 Set Up, Operating, And Servicing Instructions

BaSic SpeciFicationS

Type
Fuel
Capacity
Type
Engine Oil
Capacity
Horsepower
Run Time @ 50% Load
Sound Level
AC Output
DC Output
note: Additional specifications found in
the TECHNICAL ENGINE SPECIFI-
CATIONS chart in this manual.
The emission control system for this
engine is warranted for standards set by
the U.S. Environmental Protection Agency
and by the California Air Resources Board
(also known as CARB). For warranty
information, refer to the last pages of this
manual.
At high altitudes, the engine's carbu-
retor, governor (if so equipped), and any
other parts that control the fuel-air ratio will
need to be adjusted by a qualified me-
chanic to allow efficient high-altitude use
and to prevent damage to the engine and
any other devices used with this product.

unpacKing

When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
SKU 97906 For technical questions, please call 1-800-444-3353.
89+ octane unleaded
gasoline
1.05 Gallons
SAE 10W30
(above 32° F)
SAE 5W30
(at 32° F or below)
0.42 Quarts
2.5 HP
4 Hours, 20 Minutes
with full tank
65 dB
(2) 120 V~, 60 hz
1,000 W Rated
1,050 W Peak
16.8V to 17.2V
shown on the cover of this manual as soon
as possible.

Set up inStructionS

read the entire iMportant
SaFetY inForMation
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
FroM accidentaL
Starting:
turn the power Switch of the
equipment to its "oFF"
position, wait for the engine to
cool, and disconnect the
spark plug wire(s) before
assembling or making any
adjustments to the equipment.
operate only with proper
spark arrestor installed.
operation of this equipment
may create sparks that
can start fires around dry
vegetation.
a spark arrestor may be
required.
the operator should contact
local fire agencies for laws
or regulations relating to fire
prevention requirements.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
to prevent
SeriouS injurY
to prevent
SeriouS injurY:
Page 8