King Canada Power Force KCG-5625G Instruction Manual

King Canada Power Force KCG-5625G Instruction Manual

5625w gasoline generator with wheel kit

Advertisement

5625W GASOLINE GENERATOR
WITH WHEEL KIT
Read this manual. Do not attempt to operate this generator until you have read and understood the safety,
operation, and maintenance instructions
MODEL: KCG-5625G
INSTRUCTION MANUAL
COPYRIGHT © 2010 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Power Force KCG-5625G and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for King Canada Power Force KCG-5625G

  • Page 1 WITH WHEEL KIT Read this manual. Do not attempt to operate this generator until you have read and understood the safety, operation, and maintenance instructions MODEL: KCG-5625G INSTRUCTION MANUAL COPYRIGHT © 2010 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
  • Page 2: Warranty And Service Information

    KING CANADA shall in no event be liable for death, injuries to persons or property or for incidental, special or consequential damages arising from the use of our products. Shipping and handling charges may apply. If a defect is found, KING CANADA will either repair or replace the product.
  • Page 3 BASIC & SPECIFIC SAFETY PRECAUTIONS BE CAREFUL! KEEP FLAMMABLE DO NOT USE DO NOT USE IN DO NOT CONNECT TO IN YOUR HOUSE MATERIALS AWAY WET CONDITIONS HOUSEHOLD CIRCUIT WHEN REFUELING; STOP ENGINE! NO SMOKING! DO NOT SPILL GASOLINE! BASIC SAFETY INFORMATION WARNING! The engine muffler will be very hot after use, avoid touching the engine or muffler while they are still hot.
  • Page 4: Specific Safety Precautions

    SPECIFIC SAFETY PRECAUTIONS OPERATION OF GENERATOR IN RAIN, WET, ICY, OR FLOODED RISK OF BREATHING - INHALATION HAZARD CONDITIONS. Operate generator in clean, dry, well ventilated area. Never operate Water is an excellent conductor of electricity! Water which comes in unit in enclosed areas such as garages, basements, storage, sheds, or contact with electrically charged components can transmit electricity to in any location occupied by humans or animals.
  • Page 5 10. 20 Amp Reset. Resets the corresponding dual 120V AC outlet. fuel shut-off valve must be fully opened before starting the engine. 11. Oil gauge dipstick. Check the oil level using this oil gauge dipstick. MODEL KCG-5625G Peak Wattage (starting) 5625W Running Wattage...
  • Page 6: Pre-Start Check

    ASSEMBLY & PRE-START CHECK WARNING! To prevent permanent damage to generator or any appliances, you MUST check oil level, fuel level, air cleaner filter and unplug any load from the generator before starting. ASSEMBLY Remove all the contents from the carton and proceed to the following assembly steps; Pivot handles Install the pivot handles (A) Fig.1A to the left side of the frame using 2 hex.
  • Page 7: Starting Procedures

    PRE-START CHECK & STARTING PROCEDURES PRE-START CHECK AIR CLEANER FILTERS The air cleaner filters should be checked before every start-up and after prolonged storage, the following steps should be done when checking air cleaner filters; 1) Snap the top and bottom clips (A) Fig.3 backwards and remove the air cleaner cover (B). 2) Remove the air cleaner filters (C &...
  • Page 8: Stopping Procedures

    Overloading the generator will cause power fluctuations and can damage equipment and appliances. King Canada will not be responsible for equipment damaged as a result of voltage surges, improper operation or improper installation of the generator.
  • Page 9: Wattage Calculations

    WATTAGE CALCULATIONS WATTAGE CALCULATIONS DETERMINING WATTAGE REQUIREMENTS Note: Volts X Amps = Watts IMPORTANT! Never exceed the rated capacity of your generator. Serious damage to the generator or appliance could result from an Example: 120V X 10 Amps = 1200 Watts overload.
  • Page 10: Maintenance And Storage

    MAINTENANCE & STORAGE MAINTAINING YOUR GENERATOR Engine Oil Replacement Engine oil should be replaced after the first 20 hours of operation or after the first month of use, it should be replaced every 100 hours or 6 months after. To replace engine oil; 1) Loosen the oil gauge dipstick (A) Fig.8.
  • Page 11: Troubleshooting

    1. Electrical short in connected item. 1. Disconnect shorted load. down when loads are connected 2. Overloaded. 2. Reduce load. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.

This manual is also suitable for:

Kcg-7500g

Table of Contents