HouseWarmer HWDV080DVN-2 Installation Instructions And Owner's Manual page 36

8
9
10
after completion of gas pipe connections, all joints must be checked for gas-tightness by means of leak detector solution, soapy
water or an equivalent solution, as applicable.
cautiOn: Since some leak test solutions, including soapy water, may cause corrosion or stress cracking, all tested pipes and
joints shall be rinsed in water, unless it has been determined that the test solution is a non-corrosive type.
Page 36
BeFOre OPeratinG aPPliance
WHat tO DO iF YOu SMell GaS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
Any compound used on the threaded gas piping joint shall be resistant to any
action of liquefied petroleum gas.
A shut off valve (or appliance connector valve) must be installed in the gas
line upstream to permit servicing.
27536-0-0610