Table of Contents
Advertisement
inStallatiOn OF OPtiOnal BlOWer Kit HW125ScB
9
10
11
Page 32
CAREFULLY BEND
STRAIN
RELIEF
If the fan control does not stay in place after installation, remove
the fan control and gently bend the flanges in either direction as
needed and slide it back into place. A slight bend is all that will
be necessary. DO NOT use excessive force or tools to bend the
flanges or breakage may occur.
Pull blower cord from bottom to remove any excess wire from
inside of the heater and attach strain relief to the cord on the
underside of the heater. Insert strain relief into hole in the bottom
of the heater.
Plug power cord into wall receptacle and reattach front panel of
heater to complete installation. Verify that the plastic washers are
still in place on the front panel when replacing it.
For replacement parts see Parts List on pages 42 and 43 and Parts
View on page 44.
27536-0-0610
Hide quick links:
Advertisement
Table of Contents
